 |
 |
 |
|
|
|
[Sponsors] | ||||
December 10, 2012, 22:34
|
A simple problem about Adaptive Time steps
|
#1 |
|
Senior Member
S.Bogoda
Join Date: Jul 2012
Posts: 133
Rep Power: 13  |
I am using adaptive time steps for a simulation.
Min. time step= 0.0001S Max. time step= 0.05S My problem is, now the simulation is running around 5000 time steps, but it uses only 0.0001S for all steps. Why the solver does not change the time step (its own time step)? (I used this much of smaller time step as always solver diverged with larger time steppes, even for 0.001S) |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
| time steps problem in cfd | kvimalraj | Main CFD Forum | 0 | March 22, 2011 02:10 |
| Full pipe 3D using icoFoam | cyberbrain | OpenFOAM | 4 | March 16, 2011 09:20 |
| unsteady calcs in FLUENT | Sanjay Padhiar | Main CFD Forum | 1 | March 31, 1999 12:32 |
Threaded Mode
