 |
 |
 |
|
|
|
[Sponsors] | ||||
August 4, 2016, 11:36
|
cfxxxx
|
#1 |
|
New Member
Aslan
Join Date: Aug 2016
Posts: 3
Rep Power: 9  |
Hello friends,
Last edited by pars25; August 16, 2016 at 17:31. |
|
|
|
|
|
August 12, 2016, 03:38
|
|
#2 |
|
New Member
Aslan
Join Date: Aug 2016
Posts: 3
Rep Power: 9 |
have you no suggestions?
|
|
|
|
|
|
|
August 12, 2016, 06:09
|
|
#3 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
I don't know rigid body modelling too well. So I cannot help you.
But I would have thought a few minutes in the CFX documentation would be able to answer this question. |
|
|
|
|
|
|
August 12, 2016, 08:56
|
|
#4 |
|
New Member
Aslan
Join Date: Aug 2016
Posts: 3
Rep Power: 9 |
maybe with cel? but i dont known in which option use the cels? boundary -> mesh motion?
thx you in advance! |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| Problems with simulating TurbFOAM | barath.ezhilan | OpenFOAM | 13 | July 16, 2009 05:55 |
Linear Mode
