|
[Sponsors] |
August 20, 2001, 23:32 |
equivalencing trouble
|
#1 |
Guest
Posts: n/a
|
I'm currently performing a 2D grid convergence study using cfx4.3. I'm having trouble generating fine grids in build. When I get down to around y+=1 equivalencing misses out a lot of nodes. Then when I try to manually equivalence I just end up collapsing near-wall elements. I've tried working in a larger scale but without any success. Any tips?
Cheers, Steve |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] trouble with mesh quality from ICEM in CFX Solver | escher25 | ANSYS Meshing & Geometry | 0 | February 28, 2011 07:38 |
[GAMBIT] Trouble meshing complex VOF geometry | RPJones | ANSYS Meshing & Geometry | 2 | February 14, 2011 18:54 |
Trouble migrating oodles to pisoFoam while changing from OF 1.5 to 1.7 | sebi | OpenFOAM | 0 | December 7, 2010 09:00 |
Parallel startup trouble! | John | CFX | 9 | April 22, 2005 20:17 |
trouble with fluxsum | Jordi | Siemens | 2 | September 29, 2000 03:57 |