Combining mesh fatal error: Unequal number of ...

March 4, 2002, 09:40

What the hell this means??????????:

Unequal numbers of master and slave nodes

Master/slave pair number = 1

Transformation id = 0

Number of master nodes = 131

Number of slave nodes = 9

Please recheck the specification of the periodic surfaces.

Please help thanks Bogesz

March 5, 2002, 07:57

Your problem contains subdomains and you are inflating on surfaces adjacent to these surfaces. This can sometimes cause this error. Try without inflation and then inflate on both sides of the subdomain interface.

March 4, 2002, 09:40	Combining mesh fatal error: Unequal number of ...	#1
Bogesz Guest Posts: n/a	What the hell this means??????????: Unequal numbers of master and slave nodes Master/slave pair number = 1 Transformation id = 0 Number of master nodes = 131 Number of slave nodes = 9 Please recheck the specification of the periodic surfaces. Please help thanks Bogesz

March 5, 2002, 07:57	Re: Combining mesh fatal error: Unequal number of	#2
Helper Guest Posts: n/a	Your problem contains subdomains and you are inflating on surfaces adjacent to these surfaces. This can sometimes cause this error. Try without inflation and then inflate on both sides of the subdomain interface.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 05:25
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15