|
[Sponsors] |
February 20, 2002, 09:12 |
Advanced constraint
|
#1 |
Guest
Posts: n/a
|
Hey people,
I am building a relatively simple setup using CFX 4.3. A room with rectangular inlet and outlet, with five small heat generating rectangular prisms sit on the floor of the room. The application of constraint really annoys me. I have applied advanced constraints on the floor of the room and base of all the five heat generators, I can mesh it but while I run volmsh, it comes that inconsistentelements formed. I could not find any clue on the manual, Is there any one who knows the problem? Thank you in advance for your reply CFX4.3 user |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mykEpsilon - How to set a min/max constraint for a term with units | elektra79 | OpenFOAM | 3 | October 12, 2010 18:12 |
How can I learn advanced parts of OpenFOAM? | mmahdinia | OpenFOAM | 2 | August 27, 2009 08:35 |
advanced output | huwei | CFX | 1 | March 21, 2001 14:43 |
Advanced Constraint | Monir Hossain | CFX | 2 | January 23, 2001 10:42 |
Advanced Constraints | Sudarshan Kumar | CFX | 2 | November 7, 2000 12:56 |