|
[Sponsors] |
March 3, 2002, 08:10 |
about Turbogrid
|
#1 |
Guest
Posts: n/a
|
Hi, would somebody give me some advice on how to generate the input .curve files of tandem blade or blade with splitters by using CFX-Turbogrid.
I knew that there is a new tandem templete in the new version of Turbogrid 1.6, but i only have the old version of 1.4. Best regards, Richard |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[TurboGrid] GE rotor B geometry for Ansys turbogrid | sonny | ANSYS Meshing & Geometry | 6 | August 29, 2014 20:01 |
Importing ICEM mesh in TurboGrid | ayothicfd | Main CFD Forum | 0 | October 8, 2011 10:23 |
[TGrid] Bladegen w/o turbogrid | Biskvito | ANSYS Meshing & Geometry | 5 | September 6, 2011 08:13 |
Axial blade simulation, TurboGrid a must? | Gentry | CFX | 1 | March 19, 2009 10:20 |
How to refine leading edge mesh in TurboGrid 10 | Christian | CFX | 7 | May 30, 2006 14:24 |