|
[Sponsors] |
October 30, 2002, 21:22 |
Help please:Inlet Boundary Conditions!!!
|
#1 |
Guest
Posts: n/a
|
Hi CFX users,
I want to specify pressure and mass flow rate at the same time on inlet of a pipe. Is it possible? For example, 15atm and 1.6e-004kg s^-1. Thanks in advance. David |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
Boundary conditions for 2D Navie-Stockes simulation | L1011 | OpenFOAM | 5 | December 13, 2012 08:17 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |