Moving&Resizing an opening in CFX Build

February 13, 2003, 16:56

Hello,

I need moving&resizing an opening along one wall of my CFX model. Since the model is quite complex, I do not want to return back to SolidWorks and start over again.Is there a way to do it in Build? How?

Thanks in advance.

February 17, 2003, 16:31

Hi Basics,

You need to be more specific as to what you are doing. What version of CFX are you using? Can your moving and resizing grid be done by moving the mesh, or do you need to convert an opening to wall boundaries or vice-versa?

Regards, Glenn

February 13, 2003, 16:56	Moving&Resizing an opening in CFX Build	#1
Basics Guest Posts: n/a	Hello, I need moving&resizing an opening along one wall of my CFX model. Since the model is quite complex, I do not want to return back to SolidWorks and start over again.Is there a way to do it in Build? How? Thanks in advance.

February 17, 2003, 16:31	Re: Moving&Resizing an opening in CFX Build	#2
Glenn Horrocks Guest Posts: n/a	Hi Basics, You need to be more specific as to what you are doing. What version of CFX are you using? Can your moving and resizing grid be done by moving the mesh, or do you need to convert an opening to wall boundaries or vice-versa? Regards, Glenn

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
icem cfd geometry tin file not opening cfx 10 c	mayur	CFX	2	July 10, 2007 02:57
Fluent Vs CFX, density and pressure	Omer	CFX	9	June 28, 2007 04:13
PhD using CFX	Rui	CFX	9	May 28, 2007 05:59
CFX 10 VS CFX 11 for combustion	Jonathan Lemay	CFX	2	May 9, 2007 11:58
CFX 4.4 installation problem	Pandu Sattvika	CFX	1	December 1, 2001 04:07