|
[Sponsors] |
March 22, 2003, 13:23 |
Patran Volume Meshing
|
#1 |
Guest
Posts: n/a
|
Hi,
Could anybody please explain the difference between mesh seed and node in patran volume meshing? If i'd like to creat a hexa mesh and export it as patran neutral file, what should I do? Previously I created geometric solid, mesh seed and then mesh. After that I exported it as a neutral file but no file created and no error message reported. How can I get through this? Thank you in advance. ^_^' |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Volume 1 has invalid topology for mapped brick meshing | georgewar | ANSYS | 0 | July 24, 2011 16:02 |
'Tetrahedral meshing has failed for volume...' | Murat | FLUENT | 5 | February 19, 2011 04:22 |
Error during volume meshing "Surface is not qualified for meshing" | scorpionbay2 | STAR-CCM+ | 1 | December 21, 2009 11:14 |
Gambit: Volume Meshing | fluentnoob | ANSYS Meshing & Geometry | 4 | May 20, 2009 05:21 |
meshing lubricant volume | kenneth | FLUENT | 6 | August 7, 2000 12:37 |