|
[Sponsors] |
June 14, 2004, 09:28 |
Moving mesh
|
#1 |
Guest
Posts: n/a
|
I am doing analysis of a Adjustable chock valve using CFX 5.7. I am trying for a moving mesh simualation. But I am getting the following error.
************************************************** ERROR #002100010 has occurred in subroutine cVolSec. | | Message: | | One of the sector volumes of an element is equal to or less than | | zero. It means that there exists an illegal mesh, execution will | | be stopped immediately. | | The element sequential number is: 80 | | The element label is: 80 | | The sector volume is: -0.1077E-14 | | The location (x,y,z): 0.21066E-02 0.23395E-02 0.50000E-04 ************************************************* I am having only CFX in my hand, plz help me to get out of this problem.. Thanks & Regards, Sreevisakh |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
How to let the mesh motion solver just solve a small region near a moving boundary? | zhajingjing | OpenFOAM Running, Solving & CFD | 9 | April 28, 2016 04:15 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
Waves halted by moving mesh | Piotr Czajko | COMSOL | 1 | November 24, 2007 02:00 |