|
[Sponsors] |
October 20, 2004, 10:28 |
3 bodies in 1 part
|
#1 |
Guest
Posts: n/a
|
I create the domain as 1 part which contains 3 bodies. In CFX-Pre, I assign the volumetric heat source to B2.P3 (the 2nd body in the domain). When Solver run, the residues fluctuate and converge very slow. When I visualize the result in CFX-Post, I found that the source is at B3.P3 (the 3rd body in the domain). I check from the output file of Solver, it says that the source is at B2.P3. Then I run that definition file again after 10 loops, I stop Solver and see the result file in CFX-Post, the source is at B2.P3, then I run the definition file by Solver again. At about the 100th loop of the third adaptive mesh process, the residues fluctuate, then I stop Solver, and see the result in CFX-Pre. I found that the source is at B3.P3. This is very weird! Do anybody have an idea what wrong with my model? Thank you very much.
Atit |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem exporting line bodies form Design Modeler to Mesh Editor&Fluent | Rockda | ANSYS Meshing & Geometry | 0 | May 26, 2011 11:03 |
[ICEM] Multiple Bodies | BrolY | ANSYS Meshing & Geometry | 2 | July 5, 2010 11:04 |
surface bodies from design modeler to CFX | chisa | CFX | 0 | June 9, 2010 11:36 |
Stress Discontinuity between sliced Bodies - WORKBENCH | mankle | ANSYS | 0 | May 6, 2010 02:54 |
Any other way of converting a multi part to a single part avoiding ANSYS Design Model | LusoMundo | ANSYS Meshing & Geometry | 1 | May 14, 2009 14:35 |