|
[Sponsors] |
June 27, 2005, 08:17 |
Run-time memory configuration error
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
we are two students from berlin working on a cfd simulation of a wind turbine. We finished grid generation an some low resolution(1 Mio. Hexas) calculations. Now we try to set up our final simulation with approximately 3 Mio Hexas. We use 3 Computers everyone with 2GB of RAM (Windows XP,CFX 5.7.1,SP2). So there is about 4.8-5 GB Free RAM available. When we start the simulation with the solver, its quits with "Run-time memory configuration error - Not enough free memory is currently available on the system.Could not allocate requested memory - exiting!". This happens when the solver tries to allocate the memory for partioneering. So why is there not enough memory for partioneering a 3 Mio Hexa (Multigrid)with approx. 5 GB of RAM ? Thanks Kramer |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
error while running paraFoam! | padmanathan | OpenFOAM | 9 | October 13, 2009 05:17 |
[Netgen] Installation of Netgen in SuSE Linux 92 | edvardsenpriv | OpenFOAM Meshing & Mesh Conversion | 23 | January 16, 2009 06:12 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |