|
[Sponsors] |
January 23, 2006, 04:31 |
upwind vs high resolution
|
#1 |
Guest
Posts: n/a
|
I am running a simulation on a pump. While using the upwind model, i get a pressure diffenences of 3000pa between inlet and outlet. When i switch to high resolution, i only get 1000pa of differences. What causes the big differences. In fact i was hoping for a pressure differences of more than 3000 pa, not less while switching to the high resolution setting. Pls help. Any advices is welcome.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Resolution (CFX) vs 2nd Order Upwind (Fluent) | gravis | ANSYS | 3 | March 24, 2011 02:43 |
about upwind and high resolution | Eric | CFX | 1 | December 30, 2006 06:56 |
high resolution or upwind | erick | CFX | 2 | March 9, 2006 00:09 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |
Upwind vs High Resolution | Liwau | CFX | 2 | April 20, 2004 11:49 |