Edge of mesh -- CFD Online Discussion Forums

April 4, 2006, 19:51	Edge of mesh	#1
Nan Guest Posts: n/a	Hi, I am using icemcfd create tet mesh. I found that the nodes near the surface edge sometime create another edge. In another words, the nodes are not on the real suface edges. There is another line very close to the edge. How can I solve this problem? Thanks in advance.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 00:27
[ICEM] mesh trailing edge wedge	josip76	ANSYS Meshing & Geometry	6	September 1, 2013 12:31
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07

All times are GMT -4. The time now is 23:22.