|
[Sponsors] |
June 24, 2006, 16:20 |
TURBO-GRID-UNACTIVE STATICS MESH WINDOW
|
#1 |
Guest
Posts: n/a
|
Hello I have followed all procedures proposed by the designer of software CFX TURBIGRID 2.2.1 for the creation of grid for an centrifugal impeller pump , but when I have arrived at the last stage /analyzing the mesh/ the window â€" mesh statics- is always desactived with red color.
my question is ; how can I do to active the window *** mesh statics *** it will enable me to control and adjust grids knowing that I have generated the grid easily. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
Turbo grid mesh??? | derfarmerjoe | ANSYS | 1 | September 23, 2011 10:30 |
Grid Quality and the Solution | Faraz | Main CFD Forum | 4 | January 10, 2000 18:18 |