 |
 |
 |
|
|
|
[Sponsors] | ||||
October 30, 2006, 08:30
|
Single surface as a boundary in ICEM
|
#1 |
|
Guest
Posts: n/a
|
Can anybody point me to the correct setting for specifying a single surface (effectively a floating surface) as a boundary in ICEM. I'm pretty sure this can be done, and believe there is a button or tab somewhere for doing this. I just can't find it in ICEM!!!
Many thanks, Andrew |
|
|
||
|
October 30, 2006, 13:30
|
Re: Single surface as a boundary in ICEM
|
#2 |
|
Guest
Posts: n/a
|
If you want to save surface mesh on a zero-thickness internal wall (not a true outer boundary), you need to specify 'internal wall' in the Mesh Params by Parts panel.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| [ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM? | jash | ANSYS Meshing & Geometry | 19 | July 23, 2013 18:48 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
| Boundary condition of free surface model | Tony | FLUENT | 3 | September 27, 2004 13:48 |
Linear Mode
