|
[Sponsors] |
December 5, 2006, 06:41 |
wall boundary
|
#1 |
Guest
Posts: n/a
|
hello everybody,
i am modeling liquid solid flows in riser,i want to specify the wall boundary as a partial slip for solid phase and no slip for liquid phase. is there any way to specify the partial slip bounday condition in CFX 10.0 thanks bye CFDUSER |
|
December 5, 2006, 09:01 |
Re: wall boundary
|
#2 |
Guest
Posts: n/a
|
Dear CFDUSER,
1 - Go to CFX-Pre, open wall boundary panel 2 - On the boundary details tab, under Wall Influence on the Flow select Fluid Dependent.. 3 - On the Fluid Values tab, fill in the Free Slip and No Slip conditions for each fluid under Wall Influence on the Flow Opaque |
|
December 6, 2006, 04:30 |
Re: wall boundary
|
#3 |
Guest
Posts: n/a
|
Dear opaque
thanks for your comments, i am asking setup of user defined partial slip boundary for solid phase with regards CFDUSER |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
no-slip wall boundary condition | Atit Koonsrisuk | CFX | 3 | July 10, 2014 17:10 |
natural convection | mehrdadeng | CFX | 10 | February 25, 2011 05:25 |
CFX does not continue | Shafiul | CFX | 10 | February 17, 2011 07:57 |
CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 21:25 |
Wall Boundary Condition in k - epsilon model | abhijeet vaidya | Main CFD Forum | 0 | July 14, 2002 03:18 |