|
[Sponsors] |
August 9, 2007, 14:58 |
Turbulence models
|
#1 |
Guest
Posts: n/a
|
I have a doubt. When you have separation in the flux you have a zone where the velocity is 0 (far from the wall), so is the turbulent model working OK there? (I'm not next to the wall but the velocity is 0). If I use a model that doesn't predict well next to the wall like SSG, all the separation (even the zone far from the wall) will be not well predicted or only next to the wall?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Turbulence postprocessing | Mohsin | FLUENT | 2 | October 3, 2016 14:18 |
Incompressible Turbulence models | achinta | OpenFOAM | 4 | May 27, 2010 10:35 |
Discussion: Reason of Turbulence!! | Wen Long | Main CFD Forum | 3 | May 15, 2009 09:52 |
How to set phase dependent turbulence models? | J.Yang | CFX | 2 | August 29, 2002 15:39 |