|September 17, 2007, 03:57||
ICEM Default Setting Customization
Dear Forum Memebers,
I want to customize the settings for Default values for the ICEM like:
(1) Solver should always be ANSYS CFX (2) The tolerance for Topology Build 0.02 [mm]. I always used CAD data in mm.
(3) Tolerance for surface creation through LOFT command 0.02 mm, etc.
Is there any setting file which can be edited to control such Default values?
I would also like to knwo whether the keyboard shortcuts are possible to generate for standard operations like SAVE, OPEN, CLOSE, START OF BLOCKING, etc
Thanks a lot,
|Thread||Thread Starter||Forum||Replies||Last Post|
|GUI Setting & Keyboard shortcut in ICEM CFD10||Amod Kumar||CFX||1||July 7, 2014 05:11|
|cfd post - default setting override||turbotel||CFX||1||February 24, 2011 14:31|
|Cells with t below lower limit||Purushothama||CD-adapco||2||May 31, 2010 21:58|
|ICEM working directory setting||Bogesz||CFX||2||October 8, 2008 07:45|
|Warning 097-||AB||CD-adapco||6||November 15, 2004 05:41|