Solver Control via .pre file with Perl script

March 5, 2008, 16:20

Hi,

I tried to reset solver control using .pre file with Perl script.

When I run it, the error message says:

"Errors were encountered in the CFX Command Language for this run Error: Sub-object ' SOLVER CONTROL' is not allowed in/ "

Does it mean I can not apply solver control? or I had some thing else wrong?

Thanks

Ahlo

March 7, 2008, 12:33

It means you tried to put the SOLVER CONTROL object in the wrong part of the CCL tree. It should appear in the first level of the FLOW object:

FLOW: SOLVER CONTROL: ... END #solver control END #flow

March 5, 2008, 16:20	Solver Control via .pre file with Perl script	#1
ahlo Guest Posts: n/a	Hi, I tried to reset solver control using .pre file with Perl script. When I run it, the error message says: "Errors were encountered in the CFX Command Language for this run Error: Sub-object ' SOLVER CONTROL' is not allowed in/ " Does it mean I can not apply solver control? or I had some thing else wrong? Thanks Ahlo

March 7, 2008, 12:33	Re: Solver Control via .pre file with Perl script	#2
CycLone Guest Posts: n/a	It means you tried to put the SOLVER CONTROL object in the wrong part of the CCL tree. It should appear in the first level of the FLOW object: FLOW: SOLVER CONTROL: ... END #solver control END #flow

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh	gschaider	OpenFOAM Community Contributions	300	October 29, 2014 18:00
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 17:18
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3	flakid	OpenFOAM Installation	16	December 28, 2010 08:48
OpenFOAM Install Script	ljsh	OpenFOAM Installation	82	October 12, 2009 11:47
gcc and executable file from Mac to Linux	simone Marras	Main CFD Forum	0	April 8, 2007 15:49