|
[Sponsors] |
March 18, 2008, 16:59 |
Reynolds Number Check?
|
#1 |
Guest
Posts: n/a
|
Let's say I have a problem that I believe is laminar in nature. Is there a way to check the OUT file or set up a monitor to confirm that the Reynolds number was indeed in the laminar regime after the problem runs? Thanks.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
Low Reynolds Number k-epsilon formulation CFX 10.0 | Chris | CFX | 4 | December 7, 2009 23:51 |
Reynolds Number | Matt | CFX | 0 | February 25, 2009 05:40 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |