|
[Sponsors] |
March 19, 2008, 12:52 |
using CFX to calculate NPSHR for pump
|
#1 |
Guest
Posts: n/a
|
Hello,
I am trying to calculate the NPSHR for a centrifugal pump. I do not have the specific feature to simulate cavitation. But I think I still could just get NPSHR. I can just run the flow field at different flow rates. And get the pressure drop between the pump inlet and the minumum pressure in the pump for each flow rate. The pressure drop will be the NPSHR for various flow rates. Theoretically, I think this is correct. Am I right? Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Comparison of fluent and CFX for turbomachinery | Far | CFX | 52 | December 26, 2014 18:11 |
[ICEM] Node Number vs. Node_ID & ICEM vs. CFX | Araz | ANSYS Meshing & Geometry | 1 | April 25, 2011 11:03 |
how to calculate Nusselt number,in CFX? | prayskyer | CFX | 2 | June 19, 2006 01:24 |
how to calculate prssure force & lift force in CFX | zaidun | CFX | 4 | March 28, 2006 02:06 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |