|August 4, 2008, 14:43||
2D periodic problem
Hey all, I need some help.
I am modelling a 2D turbo machinery passage using ICEM. I have set a translational periodicity and applied it to the blocking... then applied all edge and point associations and checked the periodicty of the resulting grid. It says no problems found and I have rechecked often. Now I export the mesh into Fluent V6 but when I load the msh, Fluent gives me the following error:
Warning: Inappropriate zone type (periodic) for one-sided face zone 15.
Changing to wall. Warning: Inappropriate zone type (periodic) for one-sided face zone 16.
Changing to wall. Error: FLUENT received fatal signal (ACCESS_VIOLATION)
1. Note exact events leading to error.
2. Save case/data under new name.
3. Exit program and restart to continue.
4. Report error to your distributor.
Error Object: ()
If I just define the periodic curves/boundaries as walls, Fluent loads just fine, but without the option of making those 2 periodic.
I cannot seem to find out what I'm doing wrong... Maybe someone might have more insight into the precedure.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Periodic boundary condition||Arif||FLUENT||2||January 17, 2014 07:48|
|3Dimensional periodic boundary condition bench mark problem for incompressible||HaKu||Main CFD Forum||0||September 7, 2011 13:48|
|Gambit - meshing over airfoil wrapping (?) problem||JFDC||FLUENT||1||July 11, 2011 05:59|
|Problem in IMPORT of ICEM input file in FLUENT||csvirume||FLUENT||2||September 9, 2009 01:08|
|periodic flow problem||Alok Gupta||FLUENT||1||November 19, 2003 08:05|