|
[Sponsors] |
August 26, 2008, 09:43 |
Surface Mesh in Workbench
|
#1 |
Guest
Posts: n/a
|
I was wondering if there was anyway to either seed or specify an element type for a particular 2D region in the Workbench CFX mesher. I have a tet mesh that I am going to mate with a hex mesh and I wanted to specify pyramid elements at the interface to make mating the two grids easier. Any thoughts?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Using Surface Mesh from ANSA for Fluent Sim | tommymoose | ANSYS Meshing & Geometry | 15 | March 3, 2016 17:29 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 01:10 |
[Other] Surface aligned mesh | rpasiok | OpenFOAM Meshing & Mesh Conversion | 6 | January 7, 2008 05:55 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |