 |
 |
 |
|
|
|
[Sponsors] | ||||
December 7, 2011, 18:13
|
CFX13 Post Periodic interface
|
#1 |
|
New Member
Join Date: Dec 2011
Posts: 4
Rep Power: 14  |
I am simulating a axial compressor rotor. I used my mesh in CFX11 and CFX 13. I waited until mass is converged for both cases.
When I used CFX 11, upper periodic side and lower periodic side have same Velocity v. But, for the case with CFX 13, upper periodic side and lower periodic side have slightly different Velocity v. Especially near blade tip. What am I doing wrong? |
|
|
|
|
| Tags |
| cfx post 11, cfx post 13, periodic bc, rotor |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| problem about periodic boundary condition in Fluent | winnawinna | FLUENT | 0 | December 28, 2010 23:32 |
| [ICEM] Specifying Periodic Vertices Causes Mesh Overlap | Josh | ANSYS Meshing & Geometry | 10 | July 8, 2010 02:39 |
| Un-even Periodic Interface Problem | Jonathan | FLUENT | 2 | April 12, 2005 16:47 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Threaded Mode
