 |
 |
 |
|
|
|
[Sponsors] | ||||
January 31, 2012, 03:46
|
Help needed for my project
|
#1 |
|
Member
Shashwat
Join Date: Nov 2011
Posts: 79
Rep Power: 3  |
Dear friend
I am doing flow analysis inside the artery . considering the artery has porous property I setup all the condition . When I give run , I got error. I have attached the output file . Please help me where I did mistake Thank you Regards shashwat |
|
|
|
|
|
January 31, 2012, 05:40
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 6,989
Rep Power: 59 |
The error message says it all. You have turned extend min/max off on your profile function, but then asked for a value outside the defined profile in your initial condition. So it bombs out with an error. Read the error message carefully.
|
|
|
|
|
|
|
February 1, 2012, 03:16
|
help needed for my project
|
#3 | |
|
Member
Shashwat
Join Date: Nov 2011
Posts: 79
Rep Power: 3 |
Quote:
I also tried two ways. 1.Turned off extend min/max 2. Turned on extended min/max I am trying for the past two days for the transient analysis. I did not get the proper solution Please find my profile(t) and output file please help me to solve the problem thank you regards shashwat |
||
|
|
|
||
|
February 1, 2012, 05:07
|
|
#4 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 6,989
Rep Power: 59 |
Use a smaller time step.
|
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The FOAM Documentation Project - SHUT-DOWN | holger_marschall | OpenFOAM | 242 | March 7, 2013 12:30 |
| Help needed with project race car | richalfa | Main CFD Forum | 0 | August 6, 2010 09:40 |
| The OpenFOAM extensions project | mbeaudoin | OpenFOAM | 16 | October 9, 2007 09:33 |
| Project Advice Needed | Kapil | Main CFD Forum | 6 | September 4, 2006 08:00 |
| CFD project idea | John Cleveland | Main CFD Forum | 4 | March 8, 2005 12:55 |
Linear Mode
