|
[Sponsors] |
March 26, 2004, 03:25 |
question
|
#1 |
Guest
Posts: n/a
|
How to find the interface of inputting the boundary conditions in NUMECA- FINE-Design 3D ? thanks.
|
|
March 31, 2004, 07:51 |
Re: question
|
#2 |
Guest
Posts: n/a
|
what kind of boundary conditions would you like to impose ? CFD BC's or optimization BC's ? For reminder, FINE/Design3D is not a CFD but an optimization system, so you should not expect to define CFD BC's in this software. In this case, you should use FINE/Turbo to define the BC's, save the *.run file and select it in the FINE/Design3D window.
Best regards, Bruno |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
C question | kar | OpenFOAM Running, Solving & CFD | 26 | May 20, 2008 06:05 |
Question concerning VOF | Flora | FLUENT | 2 | July 9, 2007 09:50 |
question about LES | gino briganti | FLUENT | 3 | June 27, 2005 06:05 |
The question about Y+ | rambol | CFX | 2 | November 7, 2002 09:40 |
Another UDF question | Christian | FLUENT | 7 | July 23, 2002 04:19 |