|
[Sponsors] |
February 24, 2006, 10:14 |
the problem about design3D
|
#1 |
Guest
Posts: n/a
|
I optimized rotor 37 by fine/design3D. I can suceed in accomplishing Fitting, Screening, Database. However,there is a problem in Optimization model. After importing the .trb file in CFD package, importing a training database and setting objective fuction, there is a warning about "DATABASE FILE/NOT FOUND" when I press process/start. And the optimization can not be run.
|
|
March 21, 2006, 10:44 |
Re: the problem about design3D
|
#2 |
Guest
Posts: n/a
|
Dear Younger,
You can send your problem to support@numeca.be. They will be glad to help. Regards, Aji |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem in Modelling Heat Transfer Problem | Deepak R | FLUENT | 1 | December 6, 2007 09:37 |
Help for Fine/Design3D | stewart | Fidelity CFD | 1 | September 6, 2006 06:14 |
Using the Fine/Design3D module | yan | Fidelity CFD | 3 | September 6, 2006 06:14 |
problem in solving "wave generation" problem | san | FLUENT | 2 | April 3, 2006 23:37 |
a survey on design3d | abscissa | Fidelity CFD | 0 | December 1, 2004 02:41 |