 |
 |
 |
|
|
|
[Sponsors] | ||||
December 1, 2009, 02:44
|
Changing contact line
|
#1 |
|
New Member
Join Date: Oct 2009
Posts: 8
Rep Power: 16  |
Hello,
If you simulate the evaporation of a water droplet on a substrate the contact line stays the same while the volume is decreasing. I would like to model the evaporation of a water droplet on a substrate with a changing contact line between water and substrate. Is there an option within flow 3D to get a closer look into the behaviour of the droplet while the contact line is changing? I mean is there a simulation option to model a changing contact line? Best Regards, Leo |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 04:41 |
| Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |
Threaded Mode
