whats wrong in my simulation?

mostafa_khan · November 26, 2011, 15:34

Hi

i dont undrestand

Whats the problem?

The simulation finished in this time,you will watch in below picture

I gave -9.81 for Z-direction(SI)

What do your idea?
i hope somebody help my

Thanks.

MuxaB · December 12, 2011, 00:46

the output files, hd3msg and hd3out, should have a message at the end explaining the reason for termination, unless the solver crashed. If the latter, then there is no much you can do other than update the software.

samanabasi · December 25, 2011, 15:19

you know that pal

mostafa_khan · December 29, 2011, 13:01

Quote:

Originally Posted by samanabasi

you know that pal

hello my darling

...just this!

November 26, 2011, 15:34	whats wrong in my simulation?	#1
mostafa_khan New Member www.manvatoo.com Join Date: Nov 2011 Posts: 5 Rep Power: 2	Hi i dont undrestand Whats the problem? The simulation finished in this time,you will watch in below picture I gave -9.81 for Z-direction(SI) What do your idea? i hope somebody help my Thanks.

December 25, 2011, 15:19	hi mostafa	#3
samanabasi New Member Saman Join Date: Dec 2011 Posts: 1 Rep Power: 0	you know that pal

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
velocity profile export from a simulation onto another	sudhirlv	STAR-CCM+	1	September 12, 2010 18:57
Simple icoFoam simulation gone wrong	rieuk	OpenFOAM Running, Solving & CFD	3	March 5, 2010 02:24
Replacing mesh while running a simulation	akultane	CFX	1	November 15, 2009 13:46
Underhood simulation	Suresh	Main CFD Forum	0	October 16, 2004 06:29
Fire simulation using FDS from NIST	Jens	Main CFD Forum	1	January 22, 2004 01:53

December 12, 2011, 00:46		#2
MuxaB Senior Member michael barkhudarov Join Date: Mar 2009 Posts: 314 Rep Power: 6	the output files, hd3msg and hd3out, should have a message at the end explaining the reason for termination, unless the solver crashed. If the latter, then there is no much you can do other than update the software.