|August 7, 2012, 20:46||
Reversed flow cyclone
Join Date: Mar 2010
Location: South Korea
Posts: 249Rep Power: 9
I am simulating cyclone and getting reversed flow after about 1000 iterations. The boundary condition at the outlet is "Pressure outlet". Initially, the reversed flow occured at the start of simulation. Then, I extended the outlet pipe and reversed flow was eliminated. But, the reveresed flow started again after 1000 iterations.
My question is: Is it fine to ignore reversed flow? My results are converging properly and the reverse flow is occuring only on 50 faces out of 0.5 million cells.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Reversed Flow in Fluent Analysis||L. Hamid||FLUENT||2||November 7, 2011 04:14|
|Reversed flow at pressure outlet||Seeker Phil||FLUENT||9||January 2, 2010 06:21|
|reversed flow at velocity inlet / mass flow inlet||ib||FLUENT||1||March 26, 2007 13:11|
|reversed flow||Sastry||FLUENT||5||March 22, 2007 09:05|
|reversed flow||mukkarum||FLUENT||1||April 13, 2004 11:17|