|
[Sponsors] |
Using Pressure Inlet and Velocity Inlet Boundary Conditions Together |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 25, 2012, 11:45 |
Using Pressure Inlet and Velocity Inlet Boundary Conditions Together
|
#1 |
New Member
Abhinav
Join Date: Mar 2011
Posts: 17
Rep Power: 15 |
I am simulating Flow over an Airfoil. The Flow is compressible. For the Inlet I am using Pressure Inlet. Apart from that I have a jet on the top the Blade. For Jet Inlet I am using Velocity Inlet Boundary Condition. I ran the case it ran for 50 time steps and diverged. I wanna know if there is any way to use both of the boundary conditions together. I am using Fluent.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |