|November 19, 2012, 19:33||
Reset flow-time, time-step & iter. counter while maintaining data?? Help please
Join Date: May 2010
Posts: 57Rep Power: 7
Recently I've had a problem where due to single precision the pistons of the Stirling engine I'm modelling didn't return to their exact starting locations after one shaft revolution.
As a result, my starting point "moved" in time by about 107 time-steps.
Is there anyway I could make this point 0 (flow-time, time-step and iter. no.) while keeping the data?
I tried interpolating and (rpsetvar'flow-time 0.0) but didn't work.
After interpolating/reading the results the pressure values were wrong and rpsetvar reset the flow-time but kept the iteration count the same.
I would like to save snapshots of my solution every 250 time-steps and FLUENT saves at 250, 500, 750 etc while in my case it should now be smth like 357, 607, 857 etc which i cannot specify in the solution animation settings.
Any ideas would be greatly appreciated!
|April 20, 2014, 07:00||
Join Date: May 2012
Posts: 168Rep Power: 5
Type in the TUI:
solve montiors residual reset yes
save data file using Interpolation. Initialize the case and read the interpolated file.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Orifice Plate with a fully developed flow - Problems with convergence||jonmec||OpenFOAM Running, Solving & CFD||3||July 28, 2011 05:24|
|Time step, Number of time step, Maxximum Iterations per time step||sandisk||FLUENT||0||July 18, 2011 02:57|
|calculation diverge after continue to run||zhajingjing||OpenFOAM||0||April 28, 2010 04:35|
|How to update polyPatchbs localPoints||liu||OpenFOAM Running, Solving & CFD||6||December 30, 2005 18:27|
|Physical Reason for stability of Implicit Schemes?||radhakrishnan||Main CFD Forum||25||December 7, 2000 16:25|