 |
 |
 |
|
|
|
[Sponsors] | ||||
May 7, 2013, 05:05
|
cell skew for dynamic meshing
|
#1 |
|
Member
Join Date: Feb 2012
Posts: 59
Rep Power: 14  |
A case using dynamic mesh was set up. However, it's found that the cell skew kept increasing till stopping due to negative volume when I previewed mesh motion. I already set the maximum cell skewness to 0.8. Any idea to sort it out?
Last edited by Raymond.Leoi; May 7, 2013 at 05:55. |
|
|
|
|
|
May 7, 2013, 08:07
|
|
#2 |
|
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
I had the same problem. Luckily, I was only playing around with fluent settings and didn't rely on the results...
What helped was to decrease the time step. But still, fluent just didn't seem to care about the "maximum skewness" settings and kept the distorted cells much above that value. I don't know why...
__________________
The skeleton ran out of shampoo in the shower. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
| Cell Reynolds Number | laliong | Main CFD Forum | 12 | September 17, 2019 03:18 |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
| Dynamic Mesh.. Layering.. cell addition | kedarj14 | OpenFOAM Programming & Development | 0 | January 29, 2010 01:48 |
| How to determine the direction of cell face vectors on processor patches | sebastian_vogl | OpenFOAM Running, Solving & CFD | 0 | October 27, 2009 08:47 |
Linear Mode
