|August 20, 2013, 10:17||
Continuity does not converge
Join Date: Jul 2013
Posts: 18Rep Power: 4
I am currently doing a very simple case on natural convection. Basically, I will have a fluid domain from a piping. The 2 faces will have different temperature (hot and cold face) and the circumferential face will be adiabatic.
I am using k-epsilon model with enhanced wall treatment together with buoyancy effect and curvature correction. My y+ value is set to be 5. Y value is calculated from the max velocity ontained from the natural convection and ANSYS Mesh is used.
I have tried several time but I cannot seem to have the continuity converged. May I know what are some of the possible issue which i can look into?
Thank you for your time.
|Thread||Thread Starter||Forum||Replies||Last Post|
|AMI interDyMFoam for mixer nu problem||danny123||OpenFOAM Programming & Development||8||September 6, 2013 02:34|
|How to write k and epsilon before the abnormal end||xiuying||OpenFOAM Running, Solving & CFD||8||August 27, 2013 15:33|
|Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3||bookie56||OpenFOAM Installation||8||August 13, 2011 04:03|
|IcoFoam parallel woes||msrinath80||OpenFOAM Running, Solving & CFD||9||July 22, 2007 02:58|
|Could anybody help me see this error and give help||liugx212||OpenFOAM Running, Solving & CFD||3||January 4, 2006 19:07|