|September 5, 2013, 12:13||
Transfer Phase distribution to another case-file, VOF
Join Date: Jul 2012
Posts: 1Rep Power: 0
I have a big problem and sadly not a lot of time left.
I'm doing a two-phase simulation with VOF, transient, k-omega-SST-Model.
I patched the water phase, but I've got to much water in the system.
The mesh I got is o.k.(for FLUENT) but I think the cells are to large, because I can't reach mass convergence.
My mass convergence won't go under a certain value.
Refining the mesh with adapt is a long process and I think it would take ages
So my question is, can I transfer the phase distribution to a different mesh, which is finer than this? I
Or do you have any other ideas?
Thanks a lot for your help!
|phase distribution, problem, vof|
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to calculate mass flow rate on patches and summation of that during the run?||immortality||OpenFOAM Post-Processing||82||November 25, 2014 14:16|
|Error bulding swak4Foam||sfigato||OpenFOAM Installation||18||August 22, 2013 12:41|
|build problem swak4Foam OF 2.2.0||mcathela||OpenFOAM Installation||14||April 23, 2013 13:59|
|funkySetFields compilation error||tayo||OpenFOAM||39||December 3, 2012 06:18|
|pisoFoam compiling error with OF 1.7.1 on MAC OSX||Greg Givogue||OpenFOAM Programming & Development||3||March 4, 2011 18:18|