|September 5, 2013, 22:55||
Reference value for Area and Depth for a circular cylinder in fluent
Join Date: Nov 2012
Posts: 6Rep Power: 4
I'm working with flow over a circular cylinder while I'm not sure about the values of "area", "depth" and "length" of the cylinder in the reference values.
As in 2D modeling there is not any projected area I'm a little bit confused with these terms.
For 2D modeling the diameter of the cylinder is 0.02 m
For 3D modeling the diameter is same but this time cylinder has a finite height of 0.1 m
|circlar cylinder, reference value|
|Thread||Thread Starter||Forum||Replies||Last Post|
|can not complie fluentDataToFoam in OF2.1.1||hewei||OpenFOAM Pre-Processing||19||April 1, 2014 20:51|
|interFoam solver for free surface flow past a circular cylinder||tfuwa||OpenFOAM Running, Solving & CFD||6||June 12, 2013 08:55|
|Reference Values -Depth||wesam||FLUENT||0||January 14, 2013 11:25|
|Fluent 2D Reference Values||Adam||FLUENT||1||January 16, 2009 03:58|
|Area & Depth of Reference Value||Jongsoo||FLUENT||0||December 4, 2008 22:31|