|
[Sponsors] |
October 25, 2013, 11:36 |
Mesh quality
|
#1 |
New Member
giovanni
Join Date: Oct 2013
Posts: 2
Rep Power: 0 |
Hi all, I'm finishing a project in Fluent for educational purposes in which they ask me to do the analysis laminar-turbulent for a convergent-divergent duct in which blood flows. For the simulations I built the mesh with Gambit, with regard to the quality of the mesh, I have good values for what concerns the Equiangle and equisize skew (0.14), the aspect ratio as the value in turbulent flux (worst element) is about 50000. This value seems high, however, refers to the element that is at the worst end of the duct where the flow is fully developed, it can therefore be considered acceptable? thanks
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Polyhedral Mesh Quality in Star-CCM+ | niazaliahmed | STAR-CCM+ | 3 | March 8, 2012 13:51 |
[ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 22:04 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |