[naresh007]

Dear Friends,

I already started thread couple of days back stating some error message. Happy for the response and I resolved the issue.
My project is based on Fuel spray in engine cylinder.
To study and compare the spray length, cone angle of the spray and droplet size inside the cylinder of petrodiesel and biodiesel.
. 3 orifices at 120° each
. At the end of compression,
Air pressure = 30-40 bar at 250° C
Fuel pressure = 250 bar

Arrangement : A cylinder arrangement of a diesel engine with the two valves in the closed position. An injector is placed in the middle vertically, the nozzle tip has 3 orifices placed at 120° each. Orifice dia being 0.6mm.

The model is ready. I need procedure to get the results. I am dummy in this. I am using Ansys Fluent 14.5

Kindly help me.