|July 17, 2014, 07:35||
Transient by using staedy result
Join Date: Nov 2013
Posts: 19Rep Power: 4
I am simulating a compressor,3D via Fluent 15.
I got a convergence in steady mode by using Moving references in impeller zone.
(impeller zone consists of blade,hub and Non rotating shroud)
Now I wanna get transient by using this results, I change reference frame to moving mesh, but residuals are diverged after 400-450 iteration.
I tried with too small time step(1e-6) and 40-50 iteration per step.
Also currant number is set to 0.01 -0.1, but it does not affect.
Any suggestion ?!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Transient or Transient Blade Row?||liucheng8602||CFX||2||June 19, 2014 07:03|
|transient result in spray reactor with swirl flow||glenn creten||Main CFD Forum||1||August 14, 2012 05:10|
|Time-averaged result||lgas222||FLUENT||3||February 20, 2012 12:39|
|Transient history not recognized||DiddyPablo||CFX||0||January 9, 2012 11:18|
|Transient Result Exporting||Greg||CFX||4||May 31, 2007 17:29|