After loading mesh file into fluent, cannot see mesh or geometry

torkness · November 7, 2014, 06:38

Hello,
after loading mesh file into fluent i cannot see mesh or geometry. In the place where i should see my objects i can only see grey rectangle. There is screen shot in attachment

Has anybody seen something like that and know how to repair it?

RodriguezFatz · November 7, 2014, 06:50

Did you try clicking on "Display" -> Mesh (at the top bar)?

torkness · November 7, 2014, 07:08

Thanks for reply
Yes, i tried. There is no reaction at all. It seems like grey rectangle is in front of normal screen. I can do simulations and do 'in-build' screens but i can't see anything at this screen

UchihaMadara · January 9, 2018, 04:50

Facing the same problem, but in mesh!!!
Cannot see the geometry , but mesh statistics are generated!!

November 7, 2014, 06:50		#2
RodriguezFatz Senior Member Philipp Join Date: Jun 2011 Location: Germany Posts: 1,297 Rep Power: 26	Did you try clicking on "Display" -> Mesh (at the top bar)? __________________ The skeleton ran out of shampoo in the shower.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to calculate mass flow rate on patches and summation of that during the run?	immortality	OpenFOAM Post-Processing	104	February 16, 2021 08:46
wmake compiling new solver	mksca	OpenFOAM Programming & Development	14	June 22, 2018 06:29
[swak4Foam] funkySetFields compilation error	tayo	OpenFOAM Community Contributions	39	December 3, 2012 05:18
2.0.x on Mac OSX	niklas	OpenFOAM Installation	74	March 28, 2012 16:46
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 19:08

November 7, 2014, 07:08		#3
torkness New Member Dawid Join Date: Jun 2014 Posts: 14 Rep Power: 11	Thanks for reply Yes, i tried. There is no reaction at all. It seems like grey rectangle is in front of normal screen. I can do simulations and do 'in-build' screens but i can't see anything at this screen

January 9, 2018, 04:50		#4
UchihaMadara Member Join Date: Jan 2018 Posts: 31 Rep Power: 8	Facing the same problem, but in mesh!!! Cannot see the geometry , but mesh statistics are generated!!