|
[Sponsors] |
March 9, 2015, 03:59 |
how to make deforming zone moves
|
#1 |
New Member
shuoyuanxu
Join Date: Jun 2014
Posts: 9
Rep Power: 11 |
Hi guys
I am doing a car electroplating case. The motion of and the geometry of the car is very complex. In other to save the computational time, I decided to use layering instead of remeshing. I decompose the car motion into X-motion and Y-motion and create several zones to make it work. So here comes the question, when I put a zone as deforming, the Motion Attributes panel is deactivated. In another word, I cant set the velocity of a deforming zone. Anyone have any ideas? Thank you! Shuoyuan Xu Last edited by lostmmind; March 16, 2015 at 22:10. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] StitchMesh on two patches | anita | OpenFOAM Meshing & Mesh Conversion | 31 | April 4, 2013 11:51 |
[swak4Foam] some errors in compiling groovyBC in OF220 | immortality | OpenFOAM Community Contributions | 10 | April 1, 2013 03:46 |
A question on "Specifying Boundary Layer Deformation Smoothing" | didiean | FLUENT | 2 | January 16, 2012 21:39 |
Deforming and moving zone at the same time | Thriller | FLUENT | 2 | October 6, 2009 04:58 |
a way to make lots of money quick and easy no lies | Dob | Main CFD Forum | 0 | October 10, 2006 16:45 |