 |
 |
 |
|
|
|
[Sponsors] | ||||
March 11, 2015, 14:02
|
Initial Level
|
#1 |
|
New Member
Mohamed Refaat Abo El-Fotouh
Join Date: Nov 2014
Location: Egypt
Posts: 14
Rep Power: 11  |
Dear All
Hope any one can help me to specify a certain level of liquid in a cylinder full of air . i.e the cylinder diameter is 45mm with a 10mm level "Fluid" and air in the rest of the cylinder. can any one help??? |
|
|
|
|
|
March 12, 2015, 05:44
|
|
#2 |
|
Senior Member
Join Date: Mar 2015
Posts: 892
Rep Power: 18 |
Have you read the section on "Modelling Open Channel Flows" in the User's Guide?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 02:20 |
| Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
| pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Linear Mode
