|
[Sponsors] |
June 3, 2015, 14:47 |
Multiple frame in ANSYS FLUENT
|
#1 |
Senior Member
|
Hello,
I am doing a tutorial of multi-rotating frame in ANSYS FLUENT in which i have rotating zone of blades and a stationary zone for incoming fluid. I followed the tutorial of multi-rotating frame but I am not satisfied. Since upon giving the moving zone the rotational velocity to moving zone, the wall are still at the same position. I know if I want to move them I will be needing dynamic meshing, what in the tutorial they are trying to simulate? The tutorial is of centrifugal pump. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
looking for a smart interface matlab fluent | chary | FLUENT | 24 | June 18, 2021 09:07 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
Fluent v6.3.26 better than Ansys v12.1 | jemyungcha | FLUENT | 2 | August 24, 2012 23:10 |