|
[Sponsors] |
January 5, 2016, 21:22 |
FSI on the deform of red blood cell
|
#1 |
New Member
Cap
Join Date: Jan 2016
Posts: 5
Rep Power: 10 |
I'm simulating the deform of red blood cell in a channel flow by using FSI between ansys and Fluent. Inlet velocity is 5e-4 m/s. The initial blood is assumed to be stationary. Even if time step is set to 1.0e-7 s, the computation is also unstable. The solution stabilization method suggested by Ansys Fluent have been attempted. Any one that have experience in this issue can give me some suggestion. Thanks
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two way FSI negative cell volume in static analysis | sneaky | ANSYS | 1 | February 8, 2014 12:21 |
[General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 14:06 |
Blood flow with FSI in Ansys 12 | Marten | ANSYS | 9 | April 14, 2012 16:33 |
Reference presssure for blood flow FSI | lingdeer | CFX | 2 | September 27, 2011 16:54 |
Red blood cell | joe | CFX | 0 | February 3, 2009 03:23 |