|
[Sponsors] |
February 8, 2000, 16:17 |
cavitation model
|
#1 |
Guest
Posts: n/a
|
Dear Sir:
When I define pressure inlet and pressure outlet bondary conditions, after the solution was fully convergent; I turn on cavitation model. But the flow rate on inlet change with steps. I run 20000 steps, the flow rate on inlet still change with steps. Could you answer me this questions? Thank you |
|
February 9, 2000, 16:44 |
Re: cavitation model
|
#2 |
Guest
Posts: n/a
|
Hy,
I also tried some time ago the cavitation-model and I had the same problem. In my opinion, modeling of cavitation (and getting good results) is not yet possible. Other cfd-codes do not yet have such a model or just try the first steps in that. Jurek |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
cavitation model pressure distribution | Rahmat Arazgaldy | FLUENT | 1 | May 16, 2012 15:48 |
Cavitation model with non-isothermal flow | pitisrisuk | CFX | 0 | July 14, 2009 14:30 |
Cavitation Model | Umesh Shah | FLUENT | 0 | June 26, 2006 17:09 |
About Cavitation Model and General setting | wayland | Siemens | 0 | January 15, 2006 21:30 |
Mixture Model (cavitation) | Victor | FLUENT | 3 | April 5, 2005 04:38 |