|
[Sponsors] |
March 31, 2000, 06:56 |
Filling
|
#1 |
Guest
Posts: n/a
|
My problem is about filling simulation. To simulate filling I'm using VOF-model on Fluent 4.5. When I use a cp dependent from the temperature Fluent gives a maximum temperature of 4000K even if the inlet temperature is 1823k. Could anyone help me? Thank you. Pietro
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to track/view the filling of resin inside a mold using viscid/laminar modelFluent | gtuncol | FLUENT | 0 | August 6, 2010 23:49 |
Mold Filling simulation using VOF model. | Nitin Pathak | FLUENT | 1 | August 21, 2009 11:54 |
FILLING RESTART | AMP | FLOW-3D | 6 | December 19, 2008 03:48 |
Regarding mold filling simulation in Fluent | Nitin Pathak | FLUENT | 0 | August 10, 2007 14:19 |
Filling by capillary forces | Jochen | Main CFD Forum | 0 | November 4, 2002 04:00 |