|
[Sponsors] |
August 29, 2000, 01:04 |
Drag and Lift modelling
|
#1 |
Guest
Posts: n/a
|
Hi,
Have anybody carried out CFD for getting forces (Drag and Lift) around a bluff object at Re=1e5 to 1e6 in air ACCURATELY? How to make that accurate enough down to 10% error when compair with wind tunnel? Should I carried out an unsteady analysis, should I mesh the cell near wall down to Y^+ < 30? pls. help! yours, Desmond |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lift and Drag ??? | Yogibear | STAR-CCM+ | 5 | November 2, 2023 17:14 |
lift and drag ceofficient problem | icemaniac178 | CFX | 6 | August 17, 2011 18:40 |
Lift and Drag Monitor Point Values Converging to Zero | Josh | CFX | 24 | May 9, 2011 10:38 |
Correct lift but wrong pressure drag - possible? | zx | Main CFD Forum | 4 | July 27, 2007 23:38 |
drag and lift coefficient | Noé | Siemens | 5 | July 13, 2004 10:21 |