|
[Sponsors] |
September 7, 2001, 09:08 |
possible to create fillets in Gambit?
|
#1 |
Guest
Posts: n/a
|
hi friends,
please let me know, how can i create fillets on the edges of a 3d model in gambit, i am little confused whether it is possible to get filleted surfaces in gambit or not. thank you. |
|
September 26, 2001, 12:24 |
Re: possible to create fillets in Gambit?
|
#2 |
Guest
Posts: n/a
|
IT is possible in FLUENT to blend the edges (Introducing fillets). You can do that by: Geometry+volume+blend volumes and it should be possible to blend just edges in 2D. Cheers
|
|
October 2, 2001, 07:55 |
Re: possible to create fillets in Gambit?
|
#3 |
Guest
Posts: n/a
|
mr.peter, thank you very much for your information. hope to get some more information exchange in future. thank you, bye.
|
|
October 2, 2001, 08:04 |
Re: thank you very much peter
|
#4 |
Guest
Posts: n/a
|
mr.peter, thank you very much for your information. hope to get some more information exchange in future. thank you, bye
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
how to create 3d model using GAMBIT | fayaz | FLUENT | 5 | April 10, 2010 02:30 |
How to create *cas file from Gambit? | Sandra | FLUENT | 2 | October 4, 2007 17:46 |
Creatingfan blade profile in GAMBIT | Jenny | FLUENT | 5 | April 28, 2005 05:52 |
GAMBIT and Turbomachinery | tom | Main CFD Forum | 6 | October 21, 1999 09:50 |