|
[Sponsors] |
Modeling the interface in overlapping fluid zones |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 4, 2024, 02:35 |
Modeling the interface in overlapping fluid zones
|
#1 |
New Member
Quoc-Viet Le
Join Date: Mar 2023
Posts: 18
Rep Power: 3 |
I want to create a tube that will have the middle region act like a valve that I can open/close with a dynamic mesh to squeeze down the middle region
I want to define a motion for that middlebody in Fluent so that it moves away from the rest of the body Because my geometry has 3 bodies (All fluid-zone) that overlap each other, I created the name for each face to make interface, but I found wall-shadow when defining BC in fluent, and I cannot change them to interface BC. I tried another way by using ansys mesh but it got an "overlapping name selection" error how do I fix this? I have attached the geometry below Screenshot 2024-04-04 151854.jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to create multiple fluid zones and an interface | josephmp | FLUENT | 15 | April 18, 2021 00:28 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Gradient 0 at the interface of two fluid zones | Bruno Machado | Fluent UDF and Scheme Programming | 1 | September 23, 2016 07:35 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
surface-creation on 1 of 2 overlapping fluid zones | Volker Pawlik | FLUENT | 0 | November 17, 2000 05:15 |